Durgical
EN
Open the app

Antimicrobial susceptibility testing

  • Laboratory diagnosis

Susceptibility testing shows which antimicrobials stop the organism that grew, so treatment can be targeted.

Updated

What it is

Antimicrobial susceptibility testing (AST) exposes a pure isolate to antimicrobials and measures whether its growth is inhibited. The result, a minimum inhibitory concentration (MIC) or a zone of inhibition, is compared with clinical breakpoints and reported as susceptible, intermediate or resistant. Pooled results for a hospital form the antibiogram, which guides empirical treatment before results are available.

Key facts

  • Susceptible means a good chance of success at standard exposure; resistant means likely failure; intermediate (EUCAST now 'susceptible, increased exposure') may work with higher exposure or where the drug concentrates.
  • MIC numbers cannot be compared across drugs: each drug has its own breakpoints.
  • Breakpoints are set by expert committees from MIC distributions, pharmacokinetics and clinical outcomes, and they change over time.
  • Breakpoints can differ by site: penicillin and ceftriaxone breakpoints for pneumococcus are lower for meningitis than for pneumonia.
  • Intrinsic resistance is predictable and often not reported, such as enterococci to cephalosporins or Pseudomonas to many older drugs.
  • The antibiogram summarizes the percentage of first isolates per patient that are susceptible to each drug, usually each year.

Step by step

  1. Start from a pure isolate that is clinically relevant (not a likely contaminant or colonizer).
  2. Prepare a standardized inoculum, matched to a turbidity standard, so every test starts with the same number of bacteria.
  3. Run the test: broth dilution, disk diffusion, a gradient diffusion strip or an automated system.
  4. Incubate under standard conditions, usually overnight for common bacteria.
  5. Read the MIC (lowest concentration with no visible growth) or measure the zone diameter around each disk.
  6. Interpret against current breakpoints (for example CLSI or EUCAST), which depend on the organism, drug and infection site.
  7. Report selectively: show the narrow-spectrum options first and release broader drugs when needed.

Ways to test susceptibility

MethodResultNotes
Broth microdilutionMICReference method; doubling dilutions of each drug in small wells
Disk diffusionZone diameterCheap and flexible; a larger zone corresponds to a lower MIC
Gradient diffusion stripMIC read where the growth ellipse meets the stripUseful for single drugs and fastidious organisms
Automated systemsMIC from miniaturized broth panelsFaster, often combined with identification
Phenotypic resistance testsPresence of a mechanismCefoxitin screen for MRSA; D-test for inducible clindamycin resistance; carbapenemase tests such as the modified carbapenem inactivation method
Genotypic testsResistance genesmecA, vanA, KPC, NDM and OXA-48-like genes; fast but do not cover every mechanism

Clinical notes

  • Carbapenemase-producing Klebsiella pneumoniae (KPC) is endemic in Colombian hospitals, so carbapenem-resistant isolates are tested for carbapenemases.
  • An oxacillin- or cefoxitin-resistant S. aureus is MRSA: resistant to nearly all beta-lactams except anti-MRSA cephalosporins.
  • Mycobacterium tuberculosis needs specialized phenotypic or molecular testing at reference laboratories.

Common traps

  • A lower MIC always means the better drug: MICs cannot be compared across drugs, because each drug has its own breakpoint.
  • A small inhibition zone is a good sign: in disk diffusion a smaller zone means a higher MIC and less susceptibility.
  • A staphylococcus that tests clindamycin-susceptible is always safe to treat with it: if it is erythromycin-resistant, the D-test can reveal inducible resistance that appears during treatment.
  • The same breakpoint applies to pneumonia and meningitis: breakpoints depend on the site, and pneumococcal meningitis breakpoints are stricter because less drug reaches the CSF.
  • Every organism that grows should be tested: testing is for clinically relevant isolates, since results on contaminants or colonizers mislead treatment.

Test yourself

Think of the answer, then tap the question to see it.

An S. aureus isolate is resistant to cefoxitin. What does that mean for the choice of beta-lactam?

It is MRSA (mecA-mediated): resistant to nearly all beta-lactams except anti-MRSA cephalosporins, whatever the other beta-lactam results look like.

The same pneumococcal ceftriaxone MIC is reported susceptible from sputum but resistant from CSF. Why?

Breakpoints depend on the site: they are lower for meningitis because less drug reaches the CSF than the lung.

A staphylococcus is erythromycin-resistant and clindamycin-susceptible. Which test is needed before relying on clindamycin?

The D-test. If erythromycin induces resistance, the clindamycin zone flattens into a D shape, and clindamycin may fail during treatment.

A carbapenem-resistant Klebsiella pneumoniae grows in a Colombian ICU. Which further test is done, and why?

A carbapenemase test (phenotypic or for genes such as KPC): carbapenemase-producing Klebsiella is endemic in Colombian hospitals, and the mechanism shapes treatment and infection control.

Before culture results arrive, how is the empirical antibiotic chosen, and what changes when the susceptibility report comes back?

From the local antibiogram, which shows the percentage of isolates susceptible to each drug; the individual result then guides de-escalation to a narrower drug.

Add to my cards (5)

Connections

← General microbiology

Educational content on microorganisms; not a treatment guide and no substitute for a health professional's advice. No doses are given.

Sources: Antibiotic Sensitivity Test: MedlinePlus Medical Test (MedlinePlus (NLM), 2025); Sensitivity analysis: MedlinePlus Medical Encyclopedia (MedlinePlus (NLM), 2025); Core Elements of Hospital Antibiotic Stewardship Programs (CDC, 2024).

Spotted a mistake?We are always improving for the community. Tell us what is wrong and our team will review it.Report a mistake

Representative model, for educational purposes only.