Denture base resins and acrylics
- Dental material
Most denture bases are acrylic (PMMA): light, cheap, easy to repair and gum-coloured. They can crack, absorb water and harbour yeast if not kept clean.
What it is
Polymethyl methacrylate (PMMA) is the standard denture base polymer. Heat-cured acrylic, processed in a flask, gives the best properties; self-cured (cold-cure) acrylic is used for repairs, relines and provisional work; milled and 3D-printed resins are increasingly used in digital workflows. Flexible thermoplastic bases are an option for some partial dentures. Residual monomer from incomplete curing can irritate the mucosa and cause allergy.
Composition and properties
- Heat-cured PMMA: stronger and lower residual monomer than self-cured.
- Milled PMMA from pre-cured blocks has very low porosity and monomer.
- Acrylic absorbs some water, which slightly changes its dimensions; dentures are stored wet.
- Fractures follow fatigue (midline of upper dentures) or impact (dropping).
- Porosity and rough surfaces harbour Candida.
| Feature | Heat-cured PMMA | Self-cured (cold-cure) PMMA | Milled or 3D-printed resin |
|---|---|---|---|
| Processing | Packed in a flask and heat-cured | Sets at room temperature | Milled from pre-cured blocks or printed |
| Residual monomer | Low | Higher | Milled: very low; printed: depends on post-curing |
| Strength and porosity | Strong, low porosity | Weaker, more porous | Milled: dense; printed: depends on resin and curing |
| Typical use | Complete and partial denture bases | Repairs, relines, provisional work | Digital denture workflows |
Uses, limits and safety
- Allergy to methacrylate is rare in patients but possible; it presents as burning and redness under the denture.
- Hot water distorts acrylic dentures.
- Polished, glazed surfaces resist plaque better than rough ones.
Next step / Initial management
- Store dentures in water or a denture cleanser when out of the mouth.
- Cracked or broken denture: refer to the dentist; avoid home glues.
- Burning under a new denture with normal-looking mucosa: refer to check for residual monomer or allergy.
Common traps
- Hot water sterilises a denture safely: hot water distorts acrylic and ruins the fit
- A denture can be left out to dry overnight: acrylic changes dimension as it dries, so it is stored in water or a denture cleanser
- Burning under a new denture is always candidiasis: residual monomer irritation or, rarely, methacrylate allergy can cause it with normal-looking mucosa
- A cracked denture can be fixed with household glue: it is weak, may be toxic and roughens the base; the dentist repairs it with acrylic
Test yourself
Think of the answer, then tap the question to see it.
What is the standard denture base material?
Polymethyl methacrylate (PMMA) acrylic resin.
Why is heat-cured acrylic preferred to self-cured for denture bases?
It is stronger and has less residual monomer.
Why should dentures be stored wet?
Acrylic absorbs water; drying out can change its dimensions and fit.
A 72-year-old's upper denture split down the middle after years of use. What caused it?
A fatigue fracture along the midline from repeated flexing, often with a poor fit; refer to the dentist for repair or a new denture.
A woman feels burning under a new denture a few days after fitting, and the mucosa looks normal. What should be considered?
Irritation from residual monomer or, rarely, methacrylate allergy, as well as pressure or candidiasis; refer to the dentist.
Connections
Educational content; it does not replace assessment by a dentist or doctor and is not a clinical instruction. For facial or neck swelling with difficulty swallowing or breathing, a knocked-out tooth or bleeding that will not stop, go to an emergency department at once.
Sources: Polymeric Denture Base Materials: A Review (Polymers (PMC open access), 2023); Management of Chronic Atrophic Candidiasis (Denture Stomatitis): A Narrative Review (International Journal of Environmental Research and Public Health (PMC open access), 2023); Clinical Applications and Mechanical Properties of CAD-CAM Materials in Restorative and Prosthetic Dentistry: A Systematic Review (Journal of Functional Biomaterials (PMC open access), 2023).
Spotted a mistake?We are always improving for the community. Tell us what is wrong and our team will review it.Report a mistake
Representative model, for educational purposes only.
